12”CHIPPER SERVICE
FEED WHEEL MOTOR
91
Replace with new motor. Clean the threads
on the motor, the 1” nut, and the coupling
with degreaser before beginning to replace
all the parts.
Attach the torque arm to the new motor
using the 1/2” bolts that were removed.
Tighten the bolts and torque to 120 ft. lbs.
(The torque arm looks slightly different on
the lower feed motor, but is still held on
with two bolts.)
Put the coupling onto the motor and line up
key and keyway – always use new key. Use
a rubber mallet to seat the coupling. Strike
the coupling a couple of times. Apply
LocTite 262 (red) to the 1” nut and screw in
place. Torque the nut to 150 ft. lbs. Strike
the coupler again a couple of times with the
rubber mallet to finish seating and torque the
nut to 150 ft. lbs. again.
HIT COUPLING WITH RUBBER MALLET TO SEAT
LINE UP KEY WITH KEYWAY ON COUPLING
Summary of Contents for 1712
