12” CHIPPER SERVICE
CUTTER SYSTEM
79
•
Use the handle and put the anvil back
through the slot. Rotate the anvil back
90
°
to insert the anvil bolts.
•
Make sure the hardware is replaced in
the correct order. The square washer has
to be next to the machine. For both
anvil bolts, the adjuster eyebolt would
go on next. The lock washer will go
closest to the head of the bolt on all
bolts.
•
The adjuster bolts must be inserted
through the slot provided to make
clearance adjustments. A flat washer
goes between the nut on the adjuster bolt
and the plate.
•
Tighten the anvil bolts loosely. Put a
flat washer and a nut back on the outside
of each adjuster bolt. Do not tighten the
nut until clearance has been set.
•
ALWAYS CHECK & SET KNIFE TO
ANVIL CLEARANCE AFTER
REMOVING AND REPLACING
KNIVES OR ANVIL.
•
Go back to the Check/Adjust Clearance
earlier in this section.
•
After clearance has been set be sure to
tighten the anvil bolts and torque to
75 ft. lbs.
•
Tighten the nuts on the adjuster bolts.
•
ALWAYS REMEMBER TO CLOSE
THE CUTTER DISK HOOD AFTER
SERVICING CUTTER DISK.
•
INSTALL THE HOOD LOCK PIN
AND PADLOCK.
•
Check condition of cutter disk hood.
Make sure the hinges are not damaged
and that the hood closes completely with
no gaps or openings; check both sides.
If there are any problems go to Servicing
Cutter Disk Hood later in this section.
REPLACE ANVIL –
PUT THROUGH
OPENING &
ROTATE BACK 90
°
HARDWARE ORDER
ANVIL BOLTS:
LOCK WASHER NEXT
TO BOLT HEAD
ADJUSTER BOLT IN
BETWEEN WASHERS
SQUARE WASHER ON
LAST (NEXT TO
MACHINE)
Summary of Contents for 1712
