12” CHIPPER SERVICE
CUTTER SYSTEM
77
DANGER:
•
TURN ENGINE OFF
•
REMOVE IGNITION KEY
•
DISENGAGE CLUTCH
•
PUT FEED CONTROL BAR IN
NEUTRAL
•
ALLOW CUTTER DISK TO
COME TO A COMPLETE STOP
•
ALLOW ALL PARTS TO COOL
COMPLETELY
•
INSTALL CUTTER DISK LOCK
PIN
ANVIL REPLACEMENT
•
Check the anvil for wear when knives
have been changed and clearance is
being set. The anvil has four working
edges that can be used before having to
be replaced. Rotate the anvil to a new
working edge unless all edges are worn
and the anvil needs replacing.
•
Do not grind the anvil to get more life.
There is only a certain amount of
adjustment available for clearance and if
the anvil is ground you will loose that
adjustment capability.
•
The anvil is hardened steel made to
Carton’s specifications. Use only
Carlton anvils as replacements or
damage may occur. Purchase the new
anvil from Carlton or an authorized
dealer.
•
To rotate or replace the anvil, remove
the anvil bolts and washers. There are
three anvil bolts, each with a square
washer and a lock washer.
•
There are two adjuster eyebolts that the
anvil bolts go through.
•
Remove the nut on the outside of each
adjuster bolt.
THE ANVIL HAS FOUR WORKING EDGES. TWO OF
THESE EDGES ARE SHOWN ABOVE. FLIP THE ANVIL
OVER FOR THE OTHER TWO EDGES.
REMOVE ANVIL
BOLTS & WASHERS
REMOVE OUTSIDE NUT ON
ADJUSTER BOLT
Summary of Contents for 1712
