Canon IPF850, User Manual

Page: 450 / 694

Setting Item Description, Instructions
Paper Details (The type of pa-
per is displayed
here.)(
*1 )
Trim Edge
First
( *2 )
(See " Cutting the Leading Edge of Roll Paper Automatical-
ly .")
➔
P.366
CutDustReduct. If you choose On , a line will be printed at the cut position when
paper cutting is selected. This option reduces the amount of deb-
ris given off after cutting. It also helps prevent adhesive from stick-
ing to the cutter and keeps the cutter sharp if you use adhesive
paper.
(See "
Reducing Dust from Cutting Rolls
.")
➔
P.367
VacuumStrngth Specify the level of suction that holds paper against the Platen.
(See "
Adjusting the Vacuum Strength
.")
➔
P.570
Scan Wait Time Specify the time to wait for the ink to dry between each scan (after
the printhead finishes moving in one direction), in consideration of
how quickly the ink dries. Also specify the applicable area for the
ink drying time. Select
Entire area to apply the ink drying time af-
ter each scan until the document is fully printed. Select Leading
edge to apply the ink drying time after each scan only in the area
110–160 mm from the leading edge. (The applicable length varies
depending on the
Print Quality setting.) Note that printing will
take longer if you specify the Scan Wait Time setting. In particu-
lar, when Leading edge is selected, colors may be uneven in the
boundary between the areas with and without a drying time.
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
NearEnd
RollMrgn Specify the minimum margin at the leading edge of roll paper to
ensure better printing quality at the leading edge.
Note that if you choose
3mm , it may lower the printing quality at
the leading edge and affect feeding accuracy. The printed surface
may be scratched, and ink may adhere to the leading edge. It may
also cause the Platen to become soiled.
NearEnd Sht
Mrgn Specify a margin at the leading edge of sheets to ensure better
printing quality at the leading edge.
Note that if you choose
3mm , it may lower the printing quality at
the leading edge and affect feeding accuracy. The printed surface
may be scratched, and ink may adhere to the leading edge.
BordlessOver-
size Select the amount of oversize extension of the original during bor-
derless printing.
Normally, we recommend that you set this to
Standard .
If it is set to Little , although it will reduce soiling on the back sur-
face, white patches may remain on the printed surface.
Width Detection Specify this option to print inside boundaries or in other cases
when specifying a particular starting position for printing.
Paper width and skew are not detected if you select
Off . If paper
is loaded askew, paper jams or Platen soiling may occur.
Return Defaults Choose OK to restore Paper Details to the default values.
Paper Details Print the paper settings as specified in Paper Details .
Keep Paper Type Select On when printing on a particular type of paper regularly.
(See "
Changing the Type of Paper
.")
➔
P.350
*1:
For information on the types of paper the printer supports, refer to Paper Reference Guide .
(See "
Displaying the Paper Reference Guide
.")
➔
P.335
The types of paper indicated in the printer driver, related software, and the printer Control Panel as well are updated when you
install the printer driver from the User Software CD-ROM or if you update the information about the paper by using the Media
Configuration Tool.
(See "
Updating paper information
.")
➔
P.338
}
*2:
When using the Stacker, do not set Trim Edge First to on.The cut leading edge of the paper may cause a paper jam.
Menu Settings iPF850
User's Guide
Control Panel
Printer Menu
450