P
age
23
- Manual
FA01894-EN
- 09/2022 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
PROGRAMMING
Programming button functions
1
ESC button
The ESC button is used to perform the operations described below.
Exit the menu
Delete the changes
Go back to the previous screen
Stop the operator
2
< > buttons
The <> buttons are used to perform the operations described below.
Navigate the menu
Increase or decrease values
3
ENTER button
The ENTER button is used to perform the operations described below.
Access menus
Confi rm choice
Outside the menu, the ESC key stops the gate and the < > keys open and close the gate.
When executing a manoeuvre, press and hold the ENTER button to display the Opening, Partial Opening, Closing
and Stop commands. You can select the desired command using the <> buttons.
Getting started
Once the electrical connections have been made, proceed with commissioning. Only skilled and qualifi ed staff
may perform this operation.
Make sure that there are no obstacles in the way.
Power up the device and follow the instructions on the display.
Start programming following the wizard.
If this is not the fi rst time the board is being switched on, go to the menu Confi guration > Wizard. Follow the
indications shown on the display.
Complete programming and check the warning, safety and protection devices, and the manual release, are
working properly.
After powering up the system, the fi rst manoeuvre is always to open the gate Wait for the manoeuvre to be
completed.
Perform the fi rst manoeuvre where you can see the gate in motion and with the photocells active, including
where remotely controlled.
Press the ESC button or STOP button immediately in the event of any faults, malfunctions, strange noises or
vibrations, or unexpected behaviour in the system.
If CALIBRATION REQUIRED appears on the display, you must calibrate the travel. The panel will not accept
motion commands, except for the motor test.
