P
age
19
- Manual
FA01894-EN
- 09/2022 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Command and control devices
1
STOP button (NC contact)
Stop the gate and exclude automatic closing. Use a control device to resume movement.
When the contact is being used, it must be activated during programming.
See function [Total stop].
2
Control device (NO contact)
Open command
When the [Hold-to-run] function is active, a control device must be set to OPEN.
3
Control device (NO contact)
Partial Opening or Pedestrian command
See [Adjusting partial opening] function.
4
Control device (NO contact)
Close command
When the [Hold-to-run] function is active, a control device must be set to CLOSE.
5
Control device (NO contact)
Step-by-step command
Sequential command
See control [Function 2-7].
6
Antenna with RG58 cable
If the chosen signalling device can be fi tted with an antenna, use the terminal shown to connect it.
1 2 3 3P 4 7
BUS
