Caltest LXI AFX Series, Manual

Page: 394 / 402

AFX SERIES® OPERATION MANUAL
SECTION 13:
Service and Maintenance
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 394 of 402
Error Source Code Category Error Message Possible Cause Resolution
I/O Board
Fault 398 Error Controller is not in
operational node. An inconsistency was
detected in the power
source's internal
communication network. Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
I/O Board
Fault 454 Error Controller is not in
operational node. An inconsistency was
detected in the power
source's internal
communication network. Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
I/O Board
Fault 455 Error Missing controller node. An inconsistency was
detected in the power
source's internal
communication network. Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
I/O Board
Fault 456 Error Cannot read fault
information. An inconsistency was
detected in the power
source's internal
communication network. Turn unit off, check
parallel cable connections
if present and then turn
unit back on. If problem
recurs, contact customer
service.
2019 Error XFMR ratio is disabled. A
XMFR ratio should be set
with SYST:XMFRRATIO
command. Attempting to select AC
coupling mode
(SOURCE:COUPLING)
when no output
transformer is present or
configures. Leave coupling mode to
DIRECT (0) setting.
Consult factory for
available transformer
opions.
Table 12-1: Warnings and Error Messages Listing