AFX SERIES® OPERATION MANUAL
SECTION 8:
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Page 195 of 402
Character
ASCII
Dec value
Hex value
Carriage Return
<CR>
13
0x0d
Line Feed
<LF>
10
0x0a
8.2
Remote Control Command Descriptions by Subsystem
This section covers detailed description of the available commands by category. The
following command categories are defined.
Command Subsystem
Description
CALIBRATE
These commands perform calibration functions
MEASURE
These commands are used to measure voltage, current,
power and any other measurement parameters from the
instrument.
OUTPUT
These command control the power source output
PROGRAM
These commands control programmed settings and
transient segments
SENSE
These commands control the voltage sense modes
SOURCE
These commands are used to set instrument settings
STATUS
These commands are used to control or query status and
error messages.
SYSTEM
These commands are used to control system level setting
such as interfaces, special operating modes or other special
instrument specific functions.
Table 8-1: Available SCPI Command Subsystems
