Calrec Zeta, Operator'S Manual, Page: 98 / 144

98 Zeta
Digital Broadcast Production Console
FIlename DeSCrIPtIon
C:\Zeta\Cust1\Config.ini This file should only be altered by an approved Calrec engineer using a specifically
designed application. The file can be copied but any unauthorised changes made will
render it inoperable, including changing the date stamp of the file (such as saving even
if not edited). If the file needs to be e-mailed to Calrec for any reason it should always
be zipped to protect the file time/date stamp. A new backup copy of this file should be
made after a console upgrade.
C:\Zeta\Cust1\Setup.ini This file is updated when changes to console settings are made and saved using the
set-up application. It should not be altered by any means other than by using the set-up
application. A new backup copy of this file should be made after such changes are
made or after a software upgrade.
C:\Zeta\Cust1\Options\Options.bin
(Or C:\Zeta100\Cust1\Options.bin in
earlier software versions) This file is updated and a new backup should be made when changes to any of the
sub-pages of the options screen are made and saved.
C:\Zeta\Cust1\memories This is the default location for the user memories. However, operators can choose to
save them to any location they desire. The maintenance department should keep a
backup of the important default memories, whilst operators should be encouraged to
keep their own backups of their own memories and to update them whenever they
make important changes to them. After a software upgrade the main set of memories
will be upgraded and checked by the engineer carrying out the upgrade. A new backup
should then be made of these memories.
C:\Zeta\Cust1\Meter This is the default location for the user-definable meter configurations. You should keep
a backup copy of the files in this folder.
C:\Zeta\Cust1\Network If your console uses Hydra Audio Networking, you should also keep a backup copy of
the files in this folder. These are the configuration settings for the network units.
C:\Zeta\Cust1\Lists This is the default location for the user-definable port list configurations. You should
keep a backup copy of the files in this folder.
For customers using Compaq PC’s only:
C:\Zeta100\Cust1\A100fe1.ini
C:\Zeta100\Alphaprg\Alphaprg.ini These files are installed from the CD-ROM in a default format. The settings in these
files can vary in different Compaq PCs. The backup of these files should be updated
after a software upgrade. If a new hard-drive is fitted to the original Compaq PC, these
files should be used to over-write the versions installed by the CD-ROM.
a number of flash card slots are
provided on the front of the PC for file
backup. In addition, backup could
also be to a lan or to a USB device
which can be plugged into the front or
rear of the PC.
The following files are not installed from
the CD-ROM as they are specific to each
individual console. As such, a backup
copy should be kept of these files in-case
of PC or hard-drive failure:
fIle baCkup
The system will automatically back up
these files to a user-specified drive, if it is
set to do so. This is done using the Set-up
Application.