Calrec Zeta, Operator'S Manual

Page: 117 / 144

CalreC
Putting Sound in the Picture
117
in which case the unit will need to be
returned to Calrec for repair.
To verify the software of the processor
card, select SEND RACK S/W.
To verify all the files in the secondary /
back-up RACK processor, go to the DSP
Rack 2 page and repeat the above.
Forcing a processor into Kernel
mode
If after repeated attempts a processor
will not enter kernel mode, please carry
out the following, to force the card into
kernel mode. You may need a colleague
to assist you:
On the front edge of each processor 1.
card is a reset button, which should be
pressed.
The processor will start to re-boot, but
2.
during the boot up there is a pause.
During this pause the processor waits
to receive a command to enter kernel
mode. During this pause --!!-- is
displayed in the text window on the
right of the screen. When you see
this symbol press the K button on the
programming utility, shown highlighted
with a green box below.
If the process has been successful, the
3.
kernel message will be displayed in the
text window.