700 CLD / O2
5-04-2017
13
Rack Mounting
The front panel is designed for mounting into a standard 19-inch rack enclosure. Holes
are located on the left and right side to allow the panel to be secured in the rack by
screws. Optional rack slides allow the analyzer to be pulled out of the rack enclosure for
access.
Rear Panel
The rear panel includes the following:
1.
Rear-panel Power ON/OFF switch.
2.
Power Entry module for power connection, power switch, fuse compartment.
3.
Output connectors for analog outputs and remote functions.
4.
TCP/IP connection to connect network connector.
5.
Serial connection to connect serial connector cable.
6.
Zero Gas inlet for feeding hydrocarbon-free zero air to the analyzer. (Only present with
optional solenoid valves; otherwise this port is plugged.)
7.
Ozone Air inlet for feeding hydrocarbon-free air or oxygen to the ozone generator.
8.
Span Gas inlet for feeding calibration gas to the analyzer. (Only present in analyzers with
optional solenoid valves; otherwise this port is plugged.)
9.
Vent to exhaust from reaction chamber, ¼-inch tube fitting.
10.
Sample Gas Bypass outlet (vent) for exhaust of sample (¼-inch tube).
11.
Analyzer filter housing.
12.
Sample Gas inlet for feeding sample gas into the analyzer (¼-inch tube).