Burstner CityCar 2016, Instruction Manual

Page: 84 / 150

84
City-Car - 15/16 - Ausgabe 12/15 - 2616861 - BUE-0090-00EN
Appliances
9
9.2 Heater
Start-up When lighting the heater for the first time a small amount of smoke and odour
will occur. Immediately set the operating switch of the heater to its highest
position. Open doors and windows and ventilate well. Smoke and odour will
disappear by themselves after a while.
9.2.1 To heat properly
Hot air distribution Several air outlet nozzles (Fig. 53) are built into the vehicle. Pipes conduct the
warm air to the air outlet nozzles. Turn the air outlet nozzles in a suitable posi-
tion so the air can escape as required. To avoid draft close the air outlet noz-
zles on the dashboard and set the air distribution of the base vehicle to air
circulation.
Adjusting the air outlet
nozzles
z
Fully open: Full hot air stream
z
Half or partially open: Reduced hot air stream
When five air outlet nozzles are completely opened, less warm air escapes
through each nozzle. However, if only three air outlet nozzles are opened,
more warm air flows out of each nozzle.
9.2.2 Truma Combi hot-air heater
X
Never let gas escape unburned due to danger of explosion.
X
When filling the fuel tank, on ferries or in the garage, never run the
heater. Danger of explosion!
X
Never operate the heater in gas operation in closed spaces (e.g.
garages). Danger of poisoning and suffocation!
X
Do not damage the exhaust gas pipe.
Fig. 53 Air outlet nozzle of the hot-air
heater
Z
If there is a risk of frost and the heater is not in operation, empty the boiler.
Z
The circulation fan is automatically switched on when the hot-air heater is
activated, and it stays on. This puts an immense strain on the living area
battery, if the vehicle is not connected to an external 230 V power supply.
Take into consideration that the living area battery only has limited
reserves of energy.
Z
The hot-air heater can even run on an empty boiler.