Burstner CityCar 2016, Instruction Manual

Page: 119 / 150

119
City-Car - 15/16 - Ausgabe 12/15 - 2616861 - BUE-0090-00EN
Care
11
If animal traces are found, contact the authorised dealer or service centre. If
damage to cables has occurred, they can result in short circuits. The vehicle
could catch fire.
Before laying up the vehicle, go through the following checklist:
Activities Done
Base vehicle Completely fill fuel tank. This prevents corrosion damage within the
fuel tank system
Jack up vehicle so that the wheels do not bear any load, or move ve-
hicle every 4 weeks. This prevents any pressure points from occur-
ring on tyres and wheel bearings
Protect the tyres from direct exposure to the sun. Danger of forma-
tion of cracks!
Inflate tyres up to the recommended maximum pressure
Always provide for sufficient ventilation in the underbody area
Z Humidity or lack of oxygen e.g. by covering with plastic film
may cause optical irregularities to the underbody.
In addition observe the notes in the operating manual of the base ve-
hicle
Body All vents should be sealed with the appropriate caps and all other
openings (apart from forced ventilations) should also be sealed. This
prevents animals (e.g. mice) from gaining entry
Air the interior, all storage spaces accessible from the outside, and
the parking space (e.g. garage) every 3 weeks in order to prevent
the occurrence of condensation and resulting mould formation
Interior Place upholstery in an upright position for ventilation, and cover
Clean refrigerator
Allow refrigerator and freezer compartment doors to remain slightly
open
Search for traces of animals that have gained entry
Disconnect the flat screen from the mains and, if necessary, remove
it from the vehicle
Gas system Close regulator tap on the gas bottle
Close all gas isolator taps
Always remove gas bottles from the gas bottle compartment, even if
they are empty
Electrical system Fully charge living area and starter battery
Z Charge the battery for at least 20 hours before laying up.
Disconnect the living area battery from the 12 V power supply
Water system Empty the entire water system. Blow out the residual water from the
water pipes (0.5 bar max.). Leave the water taps on in central posi-
tion. Leave the safety/drainage valve and all drain cocks open. Ob-
serve notes in chapter 10