Burstner CityCar 2016, Instruction Manual

Page: 78 / 150

78
City-Car - 15/16 - Ausgabe 12/15 - 2616861 - BUE-0090-00EN
Electrical system
8
„
Plug the connector of the connecting cable into the socket of the camping
distributor. Ensure that the detent of the spring-mounted flap is also
engaged here.
„
Switch on the safety cut-out in the fuse box.
Checking the fault current
protection switch:
„
When the vehicle is connected to the 230 V supply, press the test button
(Fig. 43,4) of the fault current protection switch (FI-switch) (Fig. 43,3) in the
fuse box (Fig. 43,2). The fault current protection switch must trip.
„
Switch the fault current protection switch (Fig. 43,3) back on again.
Unplugging the connection:
„
Switch off the safety cut-out (Fig. 43,1) in the fuse box (Fig. 43,2).
„
Loosen the detent on the camping distributor and unplug the connecting
cable from the socket.
„
Loosen the detent on the vehicle, unplug the plug connector and close the
cover of the 230 V connection.
8.7 Fuses
8.7.1 12 V fuses
The appliances connected to the 12 V power supply in the living area are
fused individually. The fuses are accessible at different positions in the
vehicle.
Before changing fuses, take the function, value and colour of the relevant
fuses from the following specifications. When changing fuses, only use flat
fuses with the values shown below.
Fuses on the starter
battery
The fuses are installed in the vicinity of the starter battery.
X
Only replace defective fuses when the cause of the defect is known and
has been remedied.
X
Replace defective fuses only after the power supply has been turned off.
X
Never bridge or repair fuses.
X
Only replace faulty fuses with a new fuse with the same rating.
Fig. 45 Fuses on the starter battery
1 Jumbo flat fuse 40 A/orange
(for the transformer/rectifier)
2 Flat fuse 15 A/blue
(for refrigerator and charging line)