Buell XB9R 2003, Service Manual, Page: 559 / 566

7-60 2003 Buell XB9R: Electrical
HOME
11. Disconnect wiring located under sprocket cover. See
7.24 SPROCKET COVER WIRING .
12. See Figure 7-74. Remove heat shrink tubing and discon-
nect sidestand switch [133] (1).
13. Remove connector from oil pressure switch [120]. Oil
pressure switch is located on front of engine.
14. Rotate engine. See 3.3 ENGINE ROTATION FOR SER-
VICE .
15. Disconnect intake air temperature sensor [89].
16. Disconnect throttle position sensor [88].
17. Remove fan connector [97]. Fan connector is located
behind rear cylinder.
18. Remove upper fork clamp. 2.17 FORK CLAMPS,
UPPER AND LOWER .
19. Remove fairing. See 2.37 FRONT FAIRING, WIND-
SHIELD, AND MIRRORS .
20. Disconnect:
a. Flasher connector [30].
b. Bank angle sensor connector [134].
c. Electronic control module (ECM). 4.29 ELEC-
TRONIC CONTROL MODULE .
d. Instrument module connector [39].
e. Horn connectors [122].
f. Ground terminals on front of steering head.
g. Left switch housing connector [24] and right switch
housing connector [22].
h. Clutch switch [95] from left switch housing.
i. Front brake switch [121] from right switch housing.
j. headlight connector. [38].
21. Remove fuse block and relay block by removing fasten-
ers securing them to fairing support bracket.
22. Remove fuse and relay bundle clamps.
23. Remove fuse block and relay block from their brackets.
24. Remove any remaining cable straps and clamps secur-
ing wire harness and remove harness from front of vehi-
cle.
Figure 7-74. Sidestand Switch Connector [133]
8403a
1. Sidestand switch connector [133] (inside heat
shrink tubing)
2. Cable strap
1
2