Buell XB9R 2003, Service Manual, Page: 548 / 566

2003 Buell XB9R: Electrical 7-49
HOME
3. Turn vehicle ignition switch ON.
4. Begin test by pressing 0 on the tester keypad, then
pressing ENTER. The tester will scan for two seconds,
then the tester will put out a 1 Hz signal.
5. Select a test range.
a. Press 2 to select LO range (1-20 Hz).
b. Press 5 to select CEN range (21-999 Hz).
c. Press 8 to select HI range (1000-20,000 Hz).
6. After selecting a range, use the corresponding arrow
keys to accelerate through the range. As you move
through the speed range, check for smooth needle
movement.
a. If testing LO range, press 1 or 3.
b. If testing CEN range, press 4 or 6.
c. If testing HI range, press 7 or 9.
Speedometer Sensor Test
If the speedometer is inoperative, but backlighting and odom-
eter work, the speedometer sensor may not be working.
See Figure 7-61. Fabricate a test harness using the following
parts. This harness can also be used to test the tachometer.
● Two Deutsch 3-place socket housings (Part No. 72113-
94BK) and six socket terminals (Part No. 72191-94).
● Deutsch 3-place pin housing (Part No. 72103-94BK) and
three pin terminals (Part No. 72080-99Y).
● Six lengths of 18 gauge wire, each 6.0 in. (15 cm) long.
●
Test for voltage to sensor by checking for 8-12 VDC on
red wire in connector [65].
●
Then check for continuity to ground on black wire in con-
nector [65].
1. Install the test harness between the vehicle speed sen-
sor connector halves [65].
2. Raise rear wheel off floor using REAR WHEEL SUP-
PORT STAND (Part No. B-41174).
3. Place speedometer tester power switch in the ON posi-
tion. Place signal switch in the IN position.
4. Plug the speedometer tester into the test harness. Turn
vehicle ignition switch ON.
5. Press ENTER on the tester keypad.
6. Rotate the motorcycle’s rear wheel.
a. If reading on speedometer tester changes as wheel
is rotated, speedometer sensor is OK.
b. If reading does not change, vehicle speed sensor is
suspect. Install a known, good vehicle speed sensor
and test again.
Figure 7-61. Test Harness
1. Deutsch socket housing (2)
2. Deutsch pin housing
1
2
b0779x7x
1