Buell XB9R 2003, Service Manual, Page: 399 / 566

4-102 2003 Buell XB9R: Fuel System
HOME
THROTTLE POSITION SENSOR 4.36
REMOVAL
1. Remove airbox. See 4.43 AIRBOX .
2. See Figure 4-191. Disconnect throttle position sensor
connector [88].
3. See Figure 4-192. Remove two screws and washers to
detach TP sensor.
INSTALLATION
1. See Figure 4-192. Apply LOCTITE THREADLOCKER
222 (purple) to threads of fasteners.
2. Install fastener into lower mounting hole of sensor prior
to installation.
3. Attach TP sensor with both fasteners and washers.
Tighten to 16-20 in-lbs (1.8-2.3 Nm).
4. See Figure 4-193. Attach throttle position sensor con-
nector [88]. Slots on female connector [88B] must fully
engage tabs on male connector housing [88A].
NOTE
Throttle position sensor can only be calibrated using DIGITAL
TECHNICIAN (Part No. HD-44750).
5. Calibrate throttle position sensor.
Figure 4-191. Throttle Position Sensor Location
Figure 4-192. Throttle Position Sensor
Figure 4-193. Tabs on TP Sensor Connector [88A]
8753
b0995x4x
b0651x4x
Tab
Tab