Buell XB9R 2003, Service Manual, Page: 184 / 566

2003 Buell XB9R: Chassis 2-79
HOME
21. See Figure 2-112. Install upper body work onto tail
frame.
a. Connect passenger lock cable (6) by installing fer-
rule into lock lever.
b. Starting on the left side of the tail frame cover the
lock cable and wire harness and align upper body
work (1) on tail frame (8).
c. Install tail body work starting with the fastener in the
center of upper body work and between the passen-
ger and rider seat. Tighten all fasteners to 12-36 in-
lbs (1-4 Nm).
1 1
WARNING
1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
22. Install battery by threading positive cable (red) into
threaded hole first tightening to 72-96 in-lbs (8-11 Nm).
See
1.4 BATTERY MAINTENANCE .
23. Install seat and pillion. See 2.38 SEAT .
Figure 2-112. Tail Frame and Body Work Assembly
1. Upper tail body work
2. Upper tail body work fasteners
3. Passenger seat keylock
4. Passenger seat lock plate
5. Passenger seat lock retainer
6. Passenger seat lock cable
7. Tail frame fasteners
8. Tail frame
9. Lower tail body work
10. Lower tail body work fasteners
11. Trunk
12. License plate fastener
13. License plate bracket
14. Passenger seat latch
b0956x2x
9
8
11
7
6
2
4
12
13
1
3
5
14
10
12