Buell XB9R 2003, Service Manual, Page: 453 / 566

6-6 2003 Buell XB9R: Drive/Transmission
HOME
INSTALLATION
Primary Cover
1. Remove foreign material from magnetic drain plug.
Install plug and tighten to 14-30 ft-lbs (19-54 Nm).
2. Wipe gasket surface clean. Install new gasket on pri-
mary cover.
3. Install primary cover and gasket onto left crankcase half
using mounting bolts.
4. See Figure 6-6. Tighten bolts to 80-110 in-lbs (9-12.4
Nm) in sequence shown.
5. See Figure 6-1. Install new shifter lever oil seal.
6. See Figure 6-7. Fit coupling (2) over cable end (1) with
rounded side inboard and the ramp connector button out-
board. With retaining ring side of ramp assembly facing
inward, place hook of ramp (3) around coupling button
and rotate assembly counterclockwise until tang on inner
ramp fits in slot of primary cover.
7. Thread nut on adjustment screw until slot of screw is
accessible with a screwdriver. Fit nut hex into recess of
outer ramp and turn adjustment screw counterclockwise.
8. Adjust clutch. See ADJUSTMENT under 1.8 CLUTCH.
9. Adjust primary chain tension. See 6.2 PRIMARY CHAIN .
10. Fill transmission to proper level with fresh lubricant. See
PRIMARY DRIVE/ TRANSMISSION FLUID under sec-
tion 1.5 ENGINE LUBRICATION SYSTEM .
11. See Figure 6-8. Install clutch inspection cover (4) with
new gasket and three TORX screws with washers.
Tighten screws in a crosswise pattern to 84-108 in-lbs
(9.5-12.2 Nm).
12. Install rubber washer and shifter lever assembly (2).
13. Tighten engine lever pinch screw (3) to 12-14 ft-lbs 16.3-
19.0 Nm)
14. Install left footpeg support bracket. See 2.29 FOOTPEG,
HEEL GUARD AND MOUNT .
15. Install chin fairing. See 2.33 CHIN FAIRING .
1 1
WARNING
1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
16. Connect negative battery cable to battery terminal.
Tighten fastener to 60-96 in-lbs (6.8-10.9 Nm).
1 1
WARNING
1
WARNING
Pull up on seat to verify that it is properly secured, front
and rear. A loose seat may shift during vehicle operation
and startle the rider, possibly causing loss of vehicle
control resulting in death or serious injury.
17. Install seat. See 2.38 SEAT .
Figure 6-6. Primary Cover Tightening Sequence
Figure 6-7. Clutch Release Mechanism
8801
6
1
7
8
9
11
10
2
12
3
13
4
5
3
2
1
b1055x6x
1. Cable end
2. Coupling
3. Outer ramp and hook
4. Lockplate
5. Spring
5
4
Figure 6-8. Installing Primary Cover
1. Primary cover
2. Lever, engine
3. Engine lever pinch screw
4. Clutch inspection cover
4
1
3
2
8806