Micro 70 Wire Guidance
PS
S8.0
8200
F-code
Section
C-code
Version no
T-code
001
OE35
© BT Products
303
Service Manual
1997-10-24
must be moved at least two truck lengths after the
“on wire” light has turned on before the travel
direction can be reversed.
2. In the load wheel direction of travel.
a. Drive the truck in manual mode to the beginning of
the selected aisle. Position the truck so that it is
centered over the guide wire.
b. Move the manual/auto button to the auto position by
pushing the button one time. The ”manual” light will
turn off and the “auto” light will turn on. This indicates
that the wire guidance system is enabled but does
not mean that steering is automatic.
c. Slowly drive the truck along the guide wire. When the
Micro 70 system senses the guide wire it will
automatically take over the steering in the auto
mode. The “on wire” light will turn on and the
steering will be automatically controlled by the Micro
70 system.
If the guide wire is not acquired as the truck moves
over the guide wire the steering may return to the
acquisition mode and the “on wire” light will not turn
on.
If the guide wire is acquired and then lost the parking
brake will automatically set and the “loss of wire”
light will be turn on and an audible alarm will sound.
To reset the Micro 70 system after "loss of wire" has
occurred the manual/auto button must be pushed
one time to return to manual mode. Repeat steps a,
b, and c to re-acquire the guide wire.
d. Drive the truck along the guided aisle allowing the
Micro 70 system to control the steering. The truck
NOTE! When in the auto mode the truck's steering
mechanism will be turned by the Micro 70
system components. As the truck is
acquiring the guidewire the truck operator
will feel a tug on the steering wheel and the
steering wheel will be turned in the required
direction to steer the truck over the
guidewire.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
