SCR Component Checks
PS
S5.3
5230
F-code
Section
C-code
Version no
T-code
001
© BT Products
185
Service Manual
1997-04-15
11.3. 22REC, 23REC and 25REC
Remove mounting screws and lift out.
12. Instructions - EV100 Plugs
12.1. General
The plug system used in the GE EV-100 utilizes AMP
(Ampmodu 1) pins and receptacles (wire terminals). The
plugs are sealed to provide protection in the electric vehicle
environment.
12.2. Procedures
To unplug harness from EV-100
Depress latch on plug.
Grasp plug body and pull plug from terminal board. If
the plug has a shoulder near the terminal board, insert
a medium size flat blade screwdriver in this gap and
gently pry out the plug, alternating sides.
To remove a terminal from the plug body
Referring to Figure 1, insert the terminal removal tool
into the plug body (which depresses the terminal
locking lance). With a gentle push-pull motion on the
wire, remove the wire.
USE AMP REMOVAL TOOL - 91065-1.
NOTE! When replacing these devices, use
the
original hardware in the same holes, as the
insert are used for electrical connections.
NOTE! Normally the
plugs do not
require
maintenance, but should the need arise to
assemble or disassemble the plugs, correct
tools and procedures must be followed to
prevent damage to the plug body, wire
terminals or the EV-100 terminal board.
Lockin
Removal
Tool
Ledge
Figure 1
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
