Torque Generator
PS
S4.0
4130
F-code
Section
C-code
Version no
T-code
001
OE35
© BT Products
121
Service Manual
1997-10-27
24. Lubricate and install the quad seal in the groove
located in the power end housing.
25. After installing, make sure the quad seal is not twisted
and is firmly seated in its groove.
26. With the quad seal installed, turn the power end
housing over and support it in an upright position
(surface with seven mounting holes up). Lubricate and
install the first washer by aligning the bump on the
washer with the matching recess in the power end
housing.
27. Lubricate and install the second washer in the power
end housing.
28. Lubricate and install the power end shaft in the
housing.
29. Before engaging the power end housing assembly,
align the input and output shaft keyways and cross
holes. Spline on the drive and the spline in the power
end shaft should line up. With the power end assembly
installed, rotate housing to align cap screw holes.
30. Install the cap screws and torque in a criss-cross
sequence to 200 in-lb (23 N
$
m).
31. The torque generator is now ready for test and
installation.
NOTE! Careful reassemble will prevent shaft seal
damage when pushing the power end shaft
into place.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
