PS
S5.7
5440
000
Version no
T-code
F-code
Section
C-code
Direction Contactor
192
Service Manual
1997-07-15
certain the openings in the bottom of the insulators face
downward and that the insulators are properly seated in
the slots of the supports.
35. Assemble spacer, upper bus bar/contacts over the
insulators. Make
certain the contacts are seated
properly in the insulators.
36. Assemble covers (15). Make certain covers, bus bars
and contacts are in alignment and press both covers
downward with one hand...hold in this position and
install all cover screws until snug. Check to be sure all
parts are in proper alignment, and position the power
cable bolts (with lockwashers, and washers) through the
upper bus bar/contacts and spacers. Tighten bolts finger
tight into the lower bus bar/contacts.
37. Tighten cover screws to: 14-18 in.-lb [1.6-2.0 N
m].
38. Use a bar or rod to move contacts. Be sure movement is
free of binding and that tips are in correct orientation
and tips contact correct mating parts.
39. Install Forward and Reverse Contactor Assembly to
panel base plate.
Return
Summary of Contents for OE35
Page 2: ...Return ...
Page 10: ... BT Products 8 Table of Contents Return ...
Page 331: ...Return ...
