AUTO-STEER
Cam and Roller Arm Set-Up.
The recommended method of setting the Auto-Steer is:
•
Position the Harvester ‘ready to cut’.
•
With the Auto-Steer ‘
OFF
’, cut a strip of turf, for a
minimum distance of 20 feet.
It must be cut straight.
•
Stop the harvester.
The harvester will be parallel to the cut edge, the steering
wheels ‘straight ahead’, and the cutter head ‘down’.
Switch the Auto-Steer ‘ON’. Turn the Tractor ‘OFF’.
Fig.6-04
Fig.6-04
•
Remove the two 5x40mm Socket Head Screws from
the Sensor Valve End Plate ‘
A
’ and remove the End
Plate Cover ‘
B
’, complete with Rubber Seal. .
Fig.6-05
•
Swing the Auto-Steer Guide Shoe ‘left or right’, to
align the ¼ inch hole in the Cam with the hole in the
Support Plate.
•
Insert a ¼ inch Bolt ‘
C
’, through the holes to lock the
Cam in position.
•
Adjust the Cable ‘
D
’ (attached to the Cam), to the
‘mid-point’ of its stroke travel, and lock it in place.
(see Fig.6-04)
Fig.6-06
•
Back-off the Setscrew that clamps the Roller Arm to
Fig.6-05
the Roller Shaft, (See Fig.6-07).
•
Use a ‘flat blade’ screwdriver to turn the Stop Pin to
its
‘mid-point’ of travel in the cavity
. Hold the Stop
Pin in this position.
•
The Sensor Valve Internal Spool will now be in the
‘
NEUTRAL
‘ position.
Fig.6-07
•
Push the Roller Arm until the Roller is ‘hard’ against
the Cam.
•
Adjust the Roller Arm ‘up or down’ on the shaft, to
get maximum surface contact between the Roller and
the Cam.
•
Check that the Roller Arm is fully engaged on the
knurled portion of the Roller Shaft.
•
Tighten the Roller Arm Setscrew. Fig.6-06
IMPORTANT
Before operating the Auto-Steer
remove the ¼ inch Bolt from
the Cam
. Failure to do so will result in damage to the system.
Also
Fill the cavity around the Stop Pin with ‘white grease’ to prevent
corrosion forming on the Roller Shaft, causing it to ‘stick’ and
adversely affecting the operation of the Auto-Steer
Position the Sensor Valve End Plate Cover, complete with the
rubber seal, re-fit the 40mm Lg. Socket Head Screws.
Replace the Top Cover Plate.
6-02
Fig.6-07
Summary of Contents for RoboMax
