Brouwer RoboMax, Operator'S Manual

Page: 75 / 84

Pallet Lift Forks
The Pallet Lift Forks are controlled by the Computer to
move ‘down’ from the ‘upper’ position, where two layers
of sod are placed on the pallet, to the ‘middle’ position
where one more layer is placed, then to the ‘lower’ where
the remaining layers are stacked.
•
When the last layer is stacked, ‘ FULL PALLET ’
is displayed on the Cab Control Panel Screen.
•
The operator presses the ‘ UNLOAD PALLET ’
Pad, to lower the Pallet to the ground, as the
harvester continues to move forward.
•
An empty pallet is ‘injected’ (this is detected by
Proximity Sensor ‘
C ’),and the operator presses
the ‘ EMPTY PALLET ’ Pad to return the empty
pallet to the ‘upper’ position, ready to start a
new operating cycle.
Pallet Lift Forks Sensors.
The Proximity Sensors ‘
A1 – Upper’, ‘ A2 – Middle’ and
‘ A3 – Lower’ must be adjusted so that the face of the
Sensor is 1 to 3mm. from the Pallet Lift Sensor Flag ‘ B ’.
To adjust the Sensor Flag :
•
Switch the Robomax System to ‘ ON ’
•
Raise the Lift Forks to the highest position.
•
Loosen the two bolts in the Sensor Flag.
•
Slowly move the Sensor Flag ‘ DOWN ’ until the
LED on the Control Panel indicates ‘ OFF ’.
•
Slowly move the Sensor Flag ‘ UP ’ until the
LED indicates ‘ ON ’.
•
Re-tighten the Sensor Flag Bolts.
ADJUSTMENTS
5-09