ADJUSTMENTS
Roll-Up Conveyor.
The Roll-Up Tray Hanger Chain ‘
A’
, should be set so
that the clearance between the Roll-Up Tray ‘
B
’, and
the Starter Tray ‘
C’,
is
no less than 2 to 2 ½ inches
.
Roll-Up Sprockets.
The Roll-Up Conveyor ‘
D
’ completes the roll-up after the
sod has passed the Starter Tray. The speed of the Roll-
Up is determined by the Sprocket Combinations fitted at
the factory. The factory settings are for average operating
speed, for a specified cut length of sod.
The Roll-Up is chain driven by Sprocket ‘
E’
on the Main
Conveyor Sprocket Shaft, to Roll-Up Drive Sprocket ‘
F
’.
Chain tension is controlled by the Idler Pulley ‘
G
’.
Sprockets can be changed to suit operator requirements.
Refer to the Sprocket Chart for alternate Sprockets.
The Mat Front Idler Assembly must be set so that Mat is
‘just clear’ of the front cross-member. This prevents the
sod from getting ‘jammed’ and disrupting the operation.
The Rear Idler Assembly adjusts the ‘upper’ Mintex Mat
to allow enough slack, so that the mat can be pressed
Roll-up Sprockets.
down 1 ½ inches, between the front and rear sprockets.
Roll-Up Drive.
16 inch Machine.
When adjusting the shafts to tension the mats, the front Drive Sprocket 23T. (Supply 19T & 27T)
and rear shafts must be parallel, to prevent ‘conical’ rolls. Driven Sprocket 33T. (Supply 36T)
24 inch Machine.
Drive Sprocket 16T. (Supply 12T).
Driven Sprocket 36T.
Roll Flap Stabilizer.
The Roll Flap Stabilizer ‘
H
’, must be adjusted so that it
Vertical Drive Sprockets.
is positioned on the sod roll as shown below. Drive Sprocket 12T.
Driven Sprocket 24T.
Adjust as follows:
•
Loosen the Locknuts ‘
J
’.
•
Slide the Roll Flap Stabilizer ‘up’ or ‘down’ to
match the size of the rolls.
Tighten the Locknuts.
5-07
Summary of Contents for RoboMax
