AUTO-STEER
Guide Shoe Adjustment.
Fig.6-11
The Guide Shoe must be correctly adjusted, as follows :
•
Loosen the Yoke Clamp Bolt and rotate the Guide
Shoe until there is
¼ inch
clearance between the
inside edge
of the shoe and the ground.
•
Tighten the Yoke Clamp bolt.
Re-set Cylinder Chain Adjustment.
Fig.6-11
Fig.6-12
The Re-set Cylinder must be attached to the chain links
at a point that allows the Guide Shoe to travel no more
than
2 inches
past the ‘cut edge’
and onto the
un-cut turf.
IMPORTANT
The Re-set Cylinder chain links must be adjusted
before the adjustment to the Stop Bolt. See Fig.6-13.
STOP BOLT ADJUSTMENT.
Fig.6-12
Fig.6-13
The Stop Bolt determines where the Guide Shoe will
‘drop’ on the
ground
when the Auto-Steer is activated.
For most harvesting conditions the Stop Bolt is adjusted
to place the Guide Shoe 1 to 2 inches from the ‘
cut edge
’
If the conditions require adjustment to the Guide Shoe :
‘Away’
from the cut edge :
•
Back-off the Locknut and turn the Stop Bolt ‘
IN
’.
‘Closer’
to the cut edge :
•
Turn the Stop bolt ‘
OUT
’.
After adjustment
tighten the Locknut.
Fig.6-13
6-04
Summary of Contents for RoboMax
