MAINTENANCE
Rubber Conveyor Mat.
Mat Splices.
The Conveyor Mat is joined with Metal Splices.
The Mat must be joined with the lower part of the
Mat over-lapping the upper part. It is important that
any excess portion of the Threaded Stud is broken
off above the Nut when the Splice has been installed.
Special Tools are available for easy removal and
installation of the Mat Splices.
Type ‘
A
’ is for use with Air Power.
Type ‘
B’
is for use with a hand tool.
MAT SPLICE INSTALLATION
Mat Clips.
The Metal Mat Clips will wear and need replacing.
Use a chisel or similar tool to open them up for removal.
A Special Tool (Part No. KD89998) is available to make
installation fast and safe.
WARNING
Do not operate the Conveyor unless the
Stud Ends have been broken off.
Failure to observe this precaution may result
in serious injury to the operator, and/or damage to
the machine.
MAT CLIP REMOVE/INSTALL
4-12
Summary of Contents for RoboMax
