Brouwer RoboMax, Operator'S Manual

Page: 74 / 84

ADJUSTMENTS
Main Conveyor. Tracking Alignment.
WARNING
Do not make any adjustments when the tractor
engine is running. Failure to observe this warning
could result in serious injury or death
IMPORTANT
The Main Conveyor must be aligned parallel to
the tractor .
NOTE
For clarity the photographs show the Conveyor
Pivot Beam during assembly.
To adjust the Conveyor Alignment:
•
Back-off the Locknuts ‘ A ’, until they are just
‘snug’, (approximately two turns).
•
The bolt heads are located in ‘ T–Slots ’ ‘ B ’.
•
Loosen Locknuts ‘ C ’, on the Adjusting Bolts ‘ D ’.
•
Adjust the Bolts to move the Block ‘ E ’, to the
‘front’ or to the ‘rear’, until the Conveyor Frame
is parallel to the tractor, when viewed from in
front of the harvester.
•
Fully tighten Locknuts ‘ A ’ and ‘ C ’ when the
adjustment is completed.
Cutter Head. Tracking Alignment.
The Cutter Head must track in-line with the Main Conv-
eyor, to ensure that the sod is not cut at an angle, resulting
in cone shaped rolls.
To adjust the Cutter Head alignment:
•
Loosen the Rod End Locknuts ‘ F ’ on the Side
Arm Links ‘ G
’, on both sides of the Cutter Head.
NOTE
The Rod Ends are a Left Hand Thread and a
Right Hand Thread.
•
Turn the Side Arm Links on each side to extend,
or contract, until the Cutter Head Frame is parallel
to the Conveyor Frame.
•
Re-tighten the Rod End Locknuts.
5-08