ADJUSTMENTS
Return Cam Stop.
Return Cam Stops.
A different Return Cam Stop is required for each length
Part No.
Cut Length.(inches).
of cut.
The identifying Part Number is stamped into each one.
001794
18.0
Refer to the chart for the Part Numbers.
001793
24.0
001792
36.0
001791
40.5
Cut-Off
Cams.
016619
45.0
001790 *48.0/48.4
NOTE
016618
51.6
There are three Cut-Off Cams available:
014645
54.0
001788
60.0
Slow Lift –
For Cut lengths
under 54 inches.
001802
64.6
Stamped with the
letter
‘S’.
001801
68.9
001787 *72.0/72.8
Fast Lift –
For Cut lengths
54 inches to 72 inches.
001799
77.6
Stamped with the
letter ‘F’
. This is the
001376 *80.0/81.0
‘Standard’
Cam
for
Robomax.
001800
85.8
Super Lift –
For lengths
greater than 72 inches.
015553
90.0
Stamped with the
letters
‘FF’.
014974 *96.9/98.0
NOTE: * -
Indicates length change
Index Conveyor.
depending on the
Sprockets
Fitted.
The fore and aft position of the Index Conveyor Roll
‘Cleats’, relative to the Main Conveyor, is adjustable.
This determines the location of the Roll Cleats, and
ensures that the Rolls drop onto the Index Conveyor
‘between’
the Roll Cleats.
Adjustment is made by repositioning the Sensor Flag
relative to the Sensor.
IMPORTANT
When adjusting the Sensor Flag:
Start with it ‘centered’ on the Sensor, then rotate it in
small increments to obtain the correct setting.
To adjust the Conveyor position:
•
Pull back the Rubber Cover ‘
A
’.
•
Loosen Set Screw ‘
B
’, in the Sensor Flag Boss.
•
Rotate the Sensor Flag ‘
C
’ ‘
clockwise
’ to move
the Conveyor Cleats ‘
forwards
’.
•
Rotate the Sensor Flag ‘
counterclockwise
’ to
move the Conveyor Cleats ‘
rearwards
’.
Index Conveyor Mat – Tension.
Tension is maintained on the Conveyor Mat by the Side
Link Arms ‘
D
’.
As the Index Conveyor goes from its normal operating
position to the ‘eject’ position, the Link Arms
‘D’
‘push’
back against the Idler Tension Arms
‘E’
, taking the slack
out of the Conveyor Mat.
To increase the Mat tension:
•
Loosen the Locknuts ‘
F
’ at each end of the Arms.
•
Turn the Link Arms ‘clockwise’ to extend them.
•
They
must be adjusted equally,
to keep the Idler
Shaft parallel to the Conveyor Drive Shaft.
•
Re-tighten the Lock-nuts.
5-03
Summary of Contents for RoboMax
