OPERATION
Roll-Up Conveyor
The Roll–Up Conveyor
‘A’,
continues the Roll–Up
action after the Roll has passed through the Starter
Tray
‘B’
.
It is chain driven from the Main Conveyor.
Refer to Page 5-7 for adjustments.
Index Conveyor
The Index Conveyor is operated by Hydraulic Motor.
Its position is controlled by a Proximity Sensor.
The Index Conveyor
‘C’,
is synchronized to the Main
Conveyor, Robotic Arm and Bad Roll ‘Ejection’.
When a Roll is ready to be deposited onto the Index
Conveyor, a signal from the RoboMax Controller
causes the Index Conveyor to roll back ‘one position’,
to accept the completed roll.
Roll Flap ‘Stabilizer’
The Roll Flap ‘Stabilizer’ ‘
D
’, holds the sod roll as it is
transferred to the Index Conveyor. The position of the
Roll Flap is controlled by setting the ‘tooth count,
using the ‘
+
’ and ‘
-
‘ Buttons on the Control Panel LED
Display, (see page 2-1).
The ‘teeth’ are on a Sprocket ‘
E
’, located at the left
rear of the Main Conveyor. They are ‘counted’ by a
Proximity Sensor ‘
F
’.
Increasing the ‘tooth count’ moves the Roll Flap
‘counter clockwise’
Decreasing the ‘tooth count’ moves the Roll Flap
‘clock-wise’
Adjust the Roll Stabilizer to suit the selected position of
the Roll Flap.
IMPORTANT
The
Roll Flap Stabilizer must be set to ‘just’ hold the
Roll.
It must not ‘compress’ it.
Bad Roll Ejection
When a bad roll needs ejecting. The Index Conveyor
Assembly is moved, and held back, allowing the Roll
to drop past the Conveyor to the ground.
To activate the Roll Ejection refer to the Controls
Section, page 2-5.
3-03
Summary of Contents for RoboMax
