MAINTENANCE
Conveyor Mat Installation.
When the Conveyor Mat has been installed into the
Frame and onto the Sprockets, and has been ‘joined’
with Mat Splices, it will be necessary to align the Mat
so that it runs ‘parallel’ in the Frame.
The Mat is kept in alignment by the Driving Sprockets
at the top of the Conveyor, and the Crown Roller at
the front bottom of the Conveyor.
Drive Sprocket Shaft Alignment.
•
Tighten the Shaft Bearing mounting bolts, at
the right hand side of the Conveyor.
•
Loosen the left hand side Bearing Bolts ‘
A
’.
Screw the Adjusting Bolt ‘
B,
’ ‘
IN
’ until the
Shaft ‘
C
’is at 90 degrees to the Frame.
Tighten the Adjusting Bolt and the Lock-nut.
Crown Roller Alignment.
•
Loosen the Bearing Bolts ’
D
’ and the Adjust-
ing Wedges ‘
E
’. Tap the Wedges ‘
down
’ to
position the Crown Roller Shaft in the center
of the Adjusting Slots ‘
F
’. ( on both sides of
the frame). Do not fully tighten the fasteners,
to allow for final alignment adjustment.
CAUTION
Adjustments
must be done by two people.
One person to operate the controls and the other to
make the adjustments.
•
Run the Conveyor at
LOW SPEED.
•
Observe if the mat tracks to the ‘
left
’ (inner
side of the frame), tap the ‘
right side’
Adjust-
ing Wedge ‘
down
’.
•
If the mat tracks to the ‘
right
’ (outer side of the
frame), tap the ‘
left side’
Adjusting Wedge
‘
down
’.
•
Adjust until the Mat runs parallel to the frame.
•
Stop the Conveyor.
•
Tighten all fasteners.
•
Set the Roller Scraper ‘
G
’ to 1/32 in from
the Roller.
Idler Sprocket Shafts.
Two Idler Sprocket Shafts ‘
H
’, are located to the rear
of the Crown Roller,(rear-most one shown).
The Sprockets ‘
J
’, on the Idler Shaft must be adjusted to
run centrally in the Mat Slots.
•
Install the Sprockets ‘
J
’ loosely onto Shafts ’
H
’.
•
Fit the Shafts and Bearings into the frame and
lock into place with Set Screws ‘
L
’.
•
Position the Sprockets with the’ teeth’ in the
center of the Mat Slots.
•
Tighten Set Screws ‘
M
, in the Sprocket Bearings.
4-13
Summary of Contents for RoboMax
