Brouwer RoboMax, Operator'S Manual

Page: 23 / 84

NOTE
All Harvester operating controls, except for Depth of
Cut, Conveyor Lift, and Auto-Steer Fine Adjustment,
are on the Control Console at the right hand side of the
operator’s seat.
Harvester E-Stop Switch
The keyed E-Stop Switch ‘A’ in the ‘OUT’ position
enables all harvester functions except: Travel, Depth
of Cut, and Cutter Head position.
When the E-Stop Switch is pushed
‘IN’ harvester
functions are disabled, except: Travel, Depth of Cut and
Cutter Head position.
Turn the key to return to the switch to the ‘ON’ position.
WARNING
To prevent possible injury, in an emergency, push the
E-Stop Switch
‘IN’ to stop all harvester functions, except
travel.
Stop travel by ’de-clutching the transmission.
Auto-Steer Operation
The Auto-Steer is engaged, or disengaged, with the
Rocker Switch
‘B’.
Fine Adjust Control
The Fine Adjust Control ‘ J ’, adjusts the width of the waste
strip. Turn the Control Knob ‘clockwise’ to reduce the
waste strip. Turn ‘counterclockwise’ to increase it.
Cutter Blade
The Cutter Blade is engaged or disengaged with the
Rocker Switch
‘C’ .
Adjust the Cutter Blade speed with Control Knob ‘H’.
Rotate the control ‘clockwise’ to ‘increase’ the blade
speed. Rotate it ‘counterclockwise to ‘reduce’ the
blade speed.
Main Conveyor
The Main Conveyor drive is engaged or disengaged with
Rocker Switch
‘D’.
The Conveyor speed is controlled with Control Knob ‘ I ’.
Rotate the Control Knob ‘clockwise to ‘increase’ the
speed’ Rotate it ‘counterclockwise’ to reduce speed.
Pallet Injector
To engage the Pallet Injector press Rocker Switch ‘E’
‘UP’, to disengage the Pallet Injector press Rocker Switch
‘E’ ‘DOWN’.
To ‘DROP’ the Upper Pallet Injector Paddles press
Rocker Switch
‘F’ ‘DOWN’. To raise the Upper Pallet
Injector Paddles press Rocker Switch ‘F’ press ‘UP’.
To ‘DROP’ the Lower Pallet Injector Paddles press
Rocker Switch
‘G’ ‘DOWN’. To raise the Lower Pallet
Injector Paddles press Rocker Switch ‘G’ press ‘UP’.
LED Counter
The LED Counter ‘K’ displays the Main Conveyor RPM in
one mode, and the ‘tooth count’ for the Sod Roll Flap
orientation in the other mode. The Control
‘L’ selects the
mode.
The
‘+’ Control ‘N’ and the ‘-‘ Control ‘M’ adjusts the
tooth count. Increasing the tooth count, Control ‘N’,
moves the Roll Flap counterclockwise, (higher).
Decreasing the tooth count, Control
‘M’, moves the Roll
Flap clockwise, (lower), as viewed from the operator’s
position.
CONTROLS
2-01