Bosch VG5 700 Series, User Manual

Page: 59 / 82

AutoDome 700 Series IP PTZ Camera Configuring the AutoDome 700 Series | en 59
Bosch Security Systems, Inc. User Manual F.01U.273.798 | 3.0 | 2012.08
You can activate and configure encryption of the media data (video and metadata) on the
Encryption page (see Section 4.54 Encryption, page 63 ).
RCP+ port 1756
To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want
connection data to be transmitted only when encrypted, select the Off option to deactivate
the port.
Telnet support
If you want to allow only secure connections with encrypted data transmission, you must
select the Off option to deactivate Telnet support. The unit will then no longer be accessible
using the Telnet protocol.
Interface mode ETH
If necessary, select the Ethernet link type for the ETH interface. Depending on the unit
connected, it may be necessary to select a special operation type.
Network MSS (Byte)
You can set the maximum segment size for the IP packet's user data. This gives you the option
to adjust the size of the data packets to the network environment and to optimize data
transmission. Please comply with the MTU value of 1,514 bytes in UDP mode.
iSCSI MSS (Byte)
You can specify a higher MSS value for a connection to the iSCSI system than for the other
data traffic via the network. The potential value depends on the network structure. A higher
value is only useful if the iSCSI system is located in the same subnet as the AutoDome 800
Series.
Enable DynDNS
DynDNS.org is a DNS hosting service that stores IP addresses in a database ready for use. It
allows you to select the AutoDome 800 Series via the Internet using a host name, without
having to know the current IP address of the unit. You can enable this service here. To do this,
you must have an account with DynDNS.org and you must have registered the required host
name for the unit on that site.
Host name
Enter the host name registered on DynDNS.org for the AutoDome 800 Series here.
User name
Enter the user name you registered at DynDNS.org here.
Password
Enter the password you registered at DynDNS.org here.
NOTICE!
If you want to allow only secure connections with SSL encryption, you must select the Off
option for each of the parameters HTTP browser port , RCP+ port 1756 and Telnet support .
This deactivates all unsecured connections. Connections will then only be possible via the
HTTPS port.
NOTICE!
Information about the service, registration process and available host names can be found at
DynDNS.org.