48
en | Configuring the AutoDome 700 Series
AutoDome 700 Series IP PTZ Camera
F.01U.273.798 | 3.0 | 2012.08
User Manual
Bosch Security Systems, Inc.
1.
Click the
Start
button to activate the recording scheduler.
2.
Click the
Stop
button to deactivate the recording scheduler. Running recordings are
interrupted and the configuration can be changed.
Recording status
The graphic indicates the recording activity of the AutoDome 700 Series. You will see an
animated graphic while recording is taking place.
4.37
Recording Status
Certain details on the recording status are displayed here for information purposes. You
cannot change any of these settings.
4.38
Advanced Mode: Alarm
4.39
Alarm Connections
You can select how the AutoDome 700 Series responds to an alarm. In the event of an alarm,
the unit can automatically connect to a pre-defined IP address. You can enter up to ten IP
addresses to which the AutoDome 700 Series will connect in sequence in the event of an
alarm, until a connection is made.
Connect on alarm
Select
On
so that the AutoDome 700 Series automatically connects to a predefined IP address
in the event of an alarm.
By setting
Follows input 1
the unit maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
In this page, you can save a maximum of ten destination IP addresses and hence up to ten
passwords for connecting to remote stations. If connections to more than ten remote stations
are to be possible, for example when initiating connections via higher-ranking systems such as
VIDOS or Bosch Video Management System, you can store a general password here. The
AutoDome 700 Series can use this general password to connect to all remote stations
protected with the same password. In this case, proceed as follows:
1.
Select
10
from the
Number of destination IP address
list field.
2.
Enter the address
0.0.0.0
in the
Destination IP address
field.
3.
Enter your chosen password in the
Destination password
field.
4.
Define this password as the
user
password for all remote stations to which a connection
is to be possible.
NOTICE!
In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see
Section 4.19 Encoder Profile, page 33
).
Summary of Contents for VG5 700 Series
Page 1: ...AutoDome 700 Series IP PTZ Camera VG5 700 Series en User Manual ...
Page 2: ......
Page 81: ......
