Bosch LTC 1311/20 FlexiDome I, Configuration Manual

Page: 98 / 188

98 en | Devices page Bosch Video Management System
Configuration Client | V3 | 2010.07 Configuration Manual Bosch Sicherheitssysteme GmbH
– When the decoder is switched to single view or to quad view and a sequence is just
running, only the last video stream remains visible.
– When the user switches to quad view, the last cameras that have been displayed on tile
2-4 are reconnected.
– This also valid for trunklines . There is only one limitation: If the matrix camera cannot be
reconnected, this is ignored without an error message. A black tile is visible.
– When switching to single view, all trunklines that are displayed on tile 2-4 are
disconnected. Only the camera number is stored for a later switch to quad view.
Decoder Name
Displays the display name of the decoder.
Network Address
Displays the IP address of the decoder.
Logical Number
Enter the logical number of the decoder. If you enter an already used number, a message is
displayed.
Quad
Displays the position of the decoder on the quad view. 1 is left upper corner, 4 is right lower
corner.
Quad View
Select the check box to enable quad view for this decoder. On the Settings page, the
corresponding analog monitor image displays the quad view. Logical numbers are created
automatically. If you want the Operator Client user to be able to switch between quad view
and single view, then check Quad View . If you clear Quad View , the Operator Client user
cannot switch.
AMG
Displays the analog monitor group that the decoder in this row is assigned to.
Initial Camera
Click to select the camera that is displayed initially on the monitor after having started the
Operator Client. The logical number of the initial camera is displayed as the white number on
the monitor image in the Settings page.
OSD Camera Name
Check to display the camera name as OSD.
OSD Camera No.
Check to display the logical number of the camera as OSD.
OSD Position
To set the location of an OSD, select the desired entry.
17.15 Communication Devices page
Main window > Devices > Expand >
Allows you to add or configure a communication device.
You can configure the following communication devices:
– E-mail
– SMS ( GSM or SMSC dial-up provider)