Bosch Video Management System
Configuring cameras and recording settings | en
49
Bosch Sicherheitssysteme GmbH
Configuration Manual
Configuration Client | V3 | 2010.07
2.
Right-click the row with the desired values, point to
Copy Row to
, and click
Selected
Rows
.
The values are copied.
To copy one value directly:
1.
Click the row heading of the row that you want to modify.
To select more than one row press the CTRL key and point to the other row headings.
2.
Right-click the cell with the desired value, point to
Copy Cell to
, and click
Selection in
Column
.
The value is copied.
To copy a value of a cell to all other cells in this column:
Right-click the cell with the desired value, point to
Copy Cell to
, and click
Complete
Column
.
The value is copied.
To duplicate a row:
Right-click the row and click
Add Duplicated Row
.
The row is added below with a new name.
9.2
Configuring the stream quality
Main window >
Cameras and Recording
>
>
Stream Quality Settings
dialog box
To add a stream quality settings entry:
Click
to add a new entry in the list.
To remove a stream quality settings entry:
Select an entry in the list and click
to delete the entry.
You cannot delete default entries.
To rename a stream quality settings entry:
1.
Select an entry in the list.
NOTICE!
For XFM4 encoders configure the maximum bit rate with the value of the target bit rate plus
10%. The maximum bit rate is used when a scene is busy and contains motion.
NOTICE!
Bosch Video Management System uses the two streams in
dual streaming
encoders as follows:
NVR recording: Stream 2 is used for Live and pre-alarm recording, stream 1 is used for motion
and alarm recording. The streams can be switched (stream 1 for Live and pre-alarm, stream 2
for recording) for a workstation.
VRM recording and local storage: Stream 2 is used for Live, stream 1 is used for all recording
modes.
ARM based firmware: Stream 2 can also be used for recording.
The compression achieved is dependent on the stream quality settings, the image complexity,
and the level of motion in the scene. With these interdependencies, it is possible to over-
specify encoder performance. For example, with a highly complex scene with high motion, the
encoder may not be able to deliver 4
CIF
full frame rate on both streams simultaneously. Refer
to your encoder guidelines to help estimate the best settings for your conditions.
Summary of Contents for LTC 1311/20 FlexiDome I
Page 1: ...Bosch Video Management System en Configuration Manual ...
Page 2: ......
Page 187: ......
