Mating connector I
AS‐DD 6‐12‐41SN
F 02U 002 216‐01
Mating connector II
AS‐DD 6‐12‐41SA
F 02U 004 180‐01
Assign the mounting location
The mounting location is used for determination between the different M 60.
Following position definitions are possible: Front, Rear, Center, Gearbox, Front
Left, Front Right, Rear Left, Rear Right
At delivery no mounting location is set. This is signaled by an orange ‘RUN’ led
on the device. Therefore one must first assign a mounting location to the M 60
before it can be used in the project. The mounting location is permanently saved
in the M 60. If necessary you can at any time reassign a different mounting loca‐
tion following the same procedure.
A mounting location must not be used several times in one network, this would
disturb the functionality of the respective M 60.
1. In the Project Tree right click on the project name e.g. ‘New Project’ and then
select ‘Show discovered devices…’
All connected M 60 are listed.
19.1.2
19 | Enhancements
154 / 160
DDU 8 Manual
Bosch Motorsport
