Copy Control Panel Data to
Programming Key
[9] [6] [2] + [#]
√
Copy Programming Key Data
to Control Panel
[9] [6] [3] + [#]
√
Display Firmware Version
[9] [9] [9] + [#]
√
* This function can be enabled/disabled.
+ This function can be enabled/disabled individually for every user.
D = Duress User
A = Arming User
B = Basic User
S = Super User
M1 = Master User 1
M2 = Master User 2
IN = Installer
Notice!
The installer commands can be used only when all areas of the system are in disarming status
with no alarm activated and when the installer access is enabled by the user.
Code Length
The length of the codes can be set in a range from 4 to 6 digits.
Code Permissions
Tamper Reset by User
This option defines whether tampers can be reset with a user code. If this option is disabled,
tamper resets can only be performed with the installer code.
Arm / Disarm Installer
This option defines whether the arm / disarm function can be performed with a installer code.
If this option is disabled, the arm / disarm function can not be performed with an installer
code.
Macro Configuration
Macros are used to assign complicated or often used button sequences on the keypad to one
button to simplify the operation of the system. Therefore, a button sequences is entered on
the keypad, recorded and assigned to a macro. If this macro is played, the recorded button
sequence will be executed.
It is possible to record up to three macros.
Input Macro Number
In this option the number of the macro to be configured is selected. (Possible numbers are 1,
2 and 3.)
Macro without Code
This option enables/disables the quick play function of the macro. If this function is enabled,
the user can press the number of the macro for three seconds to execute the macro playing
function without entering a code.
6.2.3
6.2.4
6.2.5
52
en | Settings
AMAX panel
2015.05 | 06 | F.01U.309.277
Installation Manual
Bosch Sicherheitssysteme GmbH
