28
Please remove SIM-cards from the UO-4S while programming the panel parameters. The
XP2 jumper (see Figure 5) must be closed during programming.
RUNNING CONFIGURATION TOOL
Run UProg.
Load configuration from the device memory:
Menu
Device
→
→
→
→
Read Device Configuration
The window for searching devices connected to the computer appears on the PC display. In the
Serial Port field enter the logical number of the COM port the UO-4S is connected to. Then the Search
Devices procedure is started.
Figure 11
On completing the search procedure UProg displays the list of all the devices connected to the
selected COM port, with address and version numbers being specified for each device. Select the device
that is to be programmed.
Change Panel Address
The panel’s RS-485 network address can be changed by means of the UProg menu command
Device
→
→
→
→
Change Device Address.
In a slave mode the UO-4S address is recommended to be set to 127 while addresses of
the devices connected to the UO-4S should be set to values from 1 and higher.
Saving Configuration
To write configuration to the UO-4S memory, please click the Write Configuration to Device
button and exit the program. The UO-4S shall confirm writing the new configuration by sounding of the
built-in beeper.