37
Filter Name
Events
Armed
Partition is armed, a leakage is repaired
Alarm
Intrusion alarm, panic alarm, leakage (flood detector alarm)
Fire
Fire, Fire2
Loop Failure
Alarm loop short circuit failure, alarm loop open circuit failure, fire
protection equipment failure, service required, loop configuration error,
temperature sensor fault, noise
Communications Restored
Communication with the device/subscriber is restored
Communication Loss
Loss of communications with a device, loss of connection with a subscriber
PL Open/Short Circuit
Polling loop short circuit failure, polling loop open circuit failure, PL
communication error, PL unstable communication
Output Circuit Failure
Output open circuit failure, output short circuit failure, actuator failure,
actuator error
Off / On
An alarm loop is disconnected, and alarm loop is connected, and output is
disabled, an output is enabled, a pump is on, a pump is off, an actuator is in
initial position, an actuator is in operation position, auto mode is off, auto
mode is on
Temperature
High temperature, low temperature, normal temperature
Level
High level, low level, too high level, too low level, normal level
Auxiliary Loop
Auxiliary loop alarm, auxiliary loop restored, activation of a second
auxiliary alarm loop
Batteries
Low battery, low backup battery, backup battery restored, battery failure,
battery restored, battery test error
Charger
Power supply overload, overload repaired, RIP charger failed, RIP charger
restored
Equipment
Discharge of extinguishing agent, voice announcement activated and other
events not included in the filters
Doors
A door is forced open, a door is propped open, a door is closed (after being
forced/propped open), wrong code
Tab «Credentials»
To work with credentials and their operating authorities there is an additional toolbar in the
UProg with the tools as follows.
Load credentials from a file
Write credentials to the device
Save credentials to a file
Load credentials from the
panel memory
Add a new credential descriptor
Read a credential
Delete the selected credential de-
scriptor from the panel memory
Prior to enrolling credentials ensure that the Operation Mode parameter on the Device
tab is set to a proper value.