26
Figure 7. Connecting Readers
Inserting SIM Cards
SIM cards are to be installed into the panel after the panel has been programmed.
The primary SIM card is to be inserted into the lower slot (which is closer to the panel’s PCB),
and the backup SIM card is to be inserted into the upper slot (under the metal plate).
Closing Cover
Figure 8. How to Close the Cover
Four-wire detectors (with external powering) should be used as fire detectors. After
receiving a Fire event it is necessary to reset power of the relevant detector; for
doing so one of the panel relay outputs can be used (the tactics «Switch Off upon
Arming»).
Prior to inserting SIM cards into the UO-4S it is preferable to turn off asking PIN
codes for them by means of a cell phone. If it is required to use SIM card protected by
asking PIN then digit PINs of the primary and backup SIM cards should be specified in
SIM card settings in UProg (tab “Device”).
Insert and tighten
the screw supplied
Guide the projections of the
cover behind the base hooks
Turn a cover until a
specific click is heard