34
Listen Timeout in 10 s-Intervals (*10)
It is the time after expiry of which the panel terminates the connection established upon
activation of an alarm loop of the Phone Call type.
Phone Number
A phone number should be entered completely including the country/area code (the prefix «+»
can be used).
Password
To provide a possibility to control the panel from the cell phone, a five-digit password must be
set in this field.
To operate partitions in a slave mode, in the configuration of the control panel (in PProg.exe) the
phone number must be entered as a credential with the relevant access level to operate partitions. The
phone number should be entered in the control panel configuration along with the country and area
codes (with «8» or «7» without the «+» sign) as well as it is entered in the UO-4S itself.
Group Number
To create backup communication channels, phone numbers are combined into groups. If a
notification cannot be delivered to a first phone in the group it is transmitted to a next number. If a
notification is supposed to be sent to every phone number then the group values should be set different
for every number.
Communication Fault messages are not transmitted between the groups (directions) apart
from the GPRS channel.
Notification Type
To transmit events, one of the following notification types can be selected:
•
Contact ID (ADEMCO);
•
User SMS;
•
Egida-2 SMS;
•
Egida-3 SMS;
•
Voice Message;
•
Phone Call;
•
CSD (DC-05/DC-09)
One phone number can be used to transmit notifications of various types to it. For doing so, the
phone number should be added twice to the panel configuration with different notification types. The
two phones are to be combined in a group, thus the second notification type will be the backup one.
Enable Remote Configuring
If this parameter is set on for a subscriber then this subscriber can remotely (by SMS commands)
change Object Number, request for the balance, change the data and time, and change its phone number.
In addition, the subscriber can remotely change also the number of another subscriber if it specifies this
number in the command (after changing the number a confirmation command from the UO-4S about
changing the number is arrived to the new number).
Send Test Notification As
Test notifications are used to check operability of communication channels and can be sent to
Phone 1 and Phone 2. A Test can be sent either as an SMS (sending period is set in hours) or as a phone
call provided that a period of calling can be set in minutes or hours or calls can be given at the set time
(once or twice a day).
