Addressable Radio Link System
www.bolid.ru
90
Table 10-46. Indicating Backup Battery Test
Battery Condition
POWER LED
OK
Shows solid green light for 5 seconds
Discharged
Flashes with amber three times per second within 10 seconds
Getting Started
Open the module case and remove the insulating spacer from the battery holder. The battery test
shall be run, the result of the test being indicated by the POWER LED as shown in Table 10-46.
If the battery is operable then after testing the module is ready for connecting and programming.
Connecting and Programming
The module is to be radio connected to the ARR32 and programmed prior to connection to the mains
power.
Connect the module to the ARR32 and set its parameters in the configuration of the polling loop
controller as discussed in Sections 6, 7, and 8 of this Manual.
The S2000R-RM rev.01 occupies two addresses within the polling loop of the polling loop controller:
The first address for Relay 1;
The second address for Relay 2.
Mounting Location Considerations
Considering the mounting location for the S2000R-RM rev.01, please follow the instructions from
Section 9 of this Manual.
If the backup battery is healthy but mains power is lost then the S2000R-RM rev.01
transmits the polling loop controller a message about an equipment trouble (impossibility
to control outputs under the current power conditions) and indicates this condition as
shown in Table 10-43
Upon applying mains power the module transmits a message about restoring of the
equipment
