S2000R
13
www.bolid.ru
6. PROGRAMMING
The system should be preliminary programmed prior to installing the devices at the place
of operation
PREPARATION FOR PROGRAMMING
1. Remove the ARR32 cover;
2. Connect the antenna supplied to the antenna port on the PCB (see Figure 3-1);
3. Select the power mode of the module (see Section 4);
4. Select the radio frequency channel (see below);
5. Connect the ARR32 to a personal computer by a cable USB A(m) – USB B(m);
6. If necessary, install the driver
http://bolid.ru/files/373/566/usb_rs_exar.zip
.
SELECTING RF CHANNELS
A radio link system based on ARR32 can operate on one of four radio frequency channels as shown
in Table 6-1.
Table 6-1. RF Channels
Channel Number
Frequency Band, MHz
Channel 0
868.0 - 868.2
Channel 1
868.75 - 868.9
Channel 2
868.9 - 869.0
Channel 3
869.0 - 869.2
RF channels can be selected by means of switches S3.2—S3.4 (see Figure 3-1) or automatically.
After a channel is selected the ARR32 and all connected radio link devices start operating on the
selected channel within 90 s.
