BMW K 1100 LT, Repair Manual, Page: 45 / 364

11.11
Removing engine
•
Remove fuel tank.
•
Remove knee pads.
•
Remove fuel tank.
•
Remove lower section of fairing at left and right.
•
Remove radiator surround.
•
Drain coolant.
•
Remove radiator.
•
Attach hoist, BMW No. 00 1 510 , to oil sump.
•
Remove rear shield plate with coolant level
equalising tank.
•
Remove Motronic control unit.
e
Caution:
Detach negative battery terminal first, then positive
terminal. Connect the positive battery terminal first,
then the negative terminal.
•
Remove the battery.
e
Caution:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
•
Drain the brake fluid.
e
Caution:
Avoid damage to the brake lines.
•
(ABS I) Detach both pressure modulators and
secure them to the frame.
•
(ABS II) Remove the ABS unit.
•
Detach the brake hose fastening at the battery
carrier.
•
Remove the left footrest plate.
•
Remove the right footrest plate together with the
brake line and master brake cylinder.
•
Detach the engine wiring harness.
•
Separate the plug connections for the speed and
ABS signals.
•
Detach the throttle cable.
•
Detach the choke cable.
•
Disconnect clutch cable.
•
Remove the exhaust system.
•
Remove suspension strut.
•
Detach engine mounting at frame.
•
Secure front wheel to hoist.
•
Raise the frame with telescopic fork and frame
support,
BMW No. 46 5 620 , over the engine
block, and set it down.
•
Remove the battery holder.
•
Remove the starter motor.
•
Remove the coils.
•
Remove the main (centre) stand.
•
Take out the two lower gearbox bolts.
•
Screw the main (centre) stand on hand-tight.
•
Remove the alternator cover.
•
Screw guide pins (1) und (2), BMW No. 23 1 820 ,
into the holes with the reamed sleeve; the longer
pin (2) must be at the right.
•
Pull the gearbox off slowly.
2
1
LT110760
00 1 510
LT110830
1
2
LT110840
Downloaded from www.Manualslib.com manuals search engine