BMW K 1100 LT, Repair Manual

Page: 23 / 364

00.15
Checking brake fluid level and cor-
recting if necessary
Inspections I, II, III
Checking brake fluid level
L
Note:
When checking front brake fluid level, the cover of
the brake fluid reservoir must always be horizontal
(see SI 00 027 95 (716)).
Adding brake fluid
•
Take off the reservoir cover together with the
diaphragm
L
Note:
When adding brake fluid, note the remaining brake
pad thickness. If the brake pads are new, add fluid
up to the MAX mark.
•
Add brake fluid.
•
Replace the diaphragm and reservoir cover in
position.
•
Tighten the retaining screws without using undue
force.
Brake fluid grade:
Use only brake fluid in quality category DOT 4 (e.g.
ATE “SL” brake fluid).
Checking brake system
Inspection III
•
Check all brake lines for damage and ensure
they are fitted in the correct position.
•
Wipe clean all screw connections of the brake
lines.
•
Operate brake with force and hold for a short
space of time at this point. Then inspect brake
lines for any leakage points.
Checking ABS sensor spacing and
adjusting if necessary
Inspections I, II, III
Front sensor
•
Check sensor spacing with feeler gauge.
Sensor spacing ............................. 0.50 ... 0.55 mm
................................................ (0.0197...0.0217 in)
•
To adjust, release sensor (1) and set spacing
with spacer plates (shims) (2).
Rear sensor
•
Check sensor spacing with feeler gauge.
Sensor spacing ............................. 0.60 ... 0.65 mm
................................................ (0.0236...0.0256 in)
•
To adjust, release sensor (1) and set spacing
with spacer plates (shims) (2).
LT000310
Max.
Min.
Max.
Min.
LT000130
2
1
LT000140
2
1
Downloaded from www.Manualslib.com manuals search engine