Serial Trigger and Decode
82
Note:
If the
data’s value
is 0xXX, any data value will be matched.
Figure 10.6
7 Address & Data
•
10 address & Data
: The oscilloscope will be triggered when the following conditions are satisfied:
–
The
address’s
length must be 10 bits and the
address’s
value must be the same as the set value.
–
Data1’s
or
Data2’s
value is set to the same value of the
signal’s
data.
–
Both
Data1’s
and
Data2’s
values are set and the signal has two consecutive data values, the first is value is
Data1 and the second data value is Data2.
–
R/W can be specified as Write, Read, or
Don’t
Care.
If the
data’s value
is 0xXX, any data value will be matched.
Figure 10.7
10 Address & Data
•
Data Length
: When SDA
data’s
length is equal to the value of Byte Length and
address’s
length is the same as set
value, the oscilloscope will be triggered. Byte length is in the range of 1 to 12 bits.
Note:
