should you install it near heat sources such as radiators, or in damp rooms.
(3)
Comply with the gaps as indicated at the bottom in the picture.
(4)
Mark the drilling holes in the wall.
(5)
Check that all the points where the be.IP 4isdn is attached to the wall can bear its
weight. Ensure that there are no utility lines, cables etc located in the area where the
holes are marked.
(6)
Drill the holes at the points marked (if inserting into rawlplugs, use a 5 mm masonry
drill). Insert the rawlplug.
(7)
Screw the top two screws in in such a way that there is still a gap of about 5 mm
between the screw head and the wall.
(8)
Hang the be.IP 4isdn with the rear brackets from above behind the screw heads.
(9)
If necessary, install the sockets for the terminals. Connect the socket installation to
that of the device. The sockets are used for a permanent installation, for example in a
hallway. When they are installed, the connecting cables are connected to the connect-
ors on the device,
(10) Plug the connectors on the device into the sockets.
(11) Connect the be.IP 4isdn to the external connections. To do this, you can follow the in-
structions given on the installation poster provided.
(12) Plug the power supply unit into the 230 V socket.
(13) Plug the barrel connector on the power supply unit into the corresponding socket on
your device.
(14) Now you are ready to use the device.
3.4 Pin Assignments
3.4.1 Ethernet interfaces
The devices feature an Ethernet interface with integrated 4 port switch (ETH1 - ETH4).
The 4-port switch is used to connect individual PCs or other switches. The connection oc-
curs via RJ45 sockets.
The pin assignment for the Ethernet 10/100/1000 Base-T interface (RJ45 connector) is as
3 Mounting
bintec elmeg GmbH
12
be.IP 4isdn
