67
Source
Quench:
0
0
Redirect:
0
0
Echo
Request:
0
0
Echo
Reply:
0
0
Timestamp
Request:
0
0
Timestamp
Reply:
0
0
Address
Mask
Request:
0
0
Address
Mask
Reply:
0
0
Calls
to
icmp
error:
0
Messages
Reflected:
0
show ip
Description:
This command displays all interfaces on which IP routing has been enabled.
Example:
Router> show ip
Admin.
Oper.
Destination/
IfName
State State IP Address NetmaskBroadcast Addr
-------------------------------------------------------------------
ppp2
Enabled
Up
20.0.0.1
255.0.0.0 20.0.0.2
lan Enabled
Up
110.0.0.1 255.0.0.0
110.255.255.255
dlci16
Enabled
Up
10.0.0.1
255.0.0.0 10.0.0.2
dlci17
Enabled
Up
(Unnumbered)
show ip <interface name>
Description:
This command displays the IP configuration over the specified interface.
Example:
Router> show ip lan
Interface: lan
----------------------------------------------------------------
IP Address:
192.168.168.230
Netmask:
255.255.255.0
Dest. IP Address:
192.168.168.255
Opr./Admin. State: Up
RIP State:
Active Ver.1
IP Multicast:
Disabled
show ip routing table
Description:
This command displays the IP routing table. Each entry in the routing table corresponds to a
network or a host, and contains necessary information that is required for routing data packets to that
network or host. For example, entry 8 means that to send a packet to 110.0.0.1, the packet should be sent
to the next hop router (gateway), whose IP address is 40.0.0.5. The destination is, according to the table, 5
hops away (where a “hop” is a traversal of a link from one router to another).
Any entry whose Interface Name is
lo
means the corresponding destination network is locally attached to
one of the serial interfaces. Also, if the Gateway field is empty, it means either the destination IP network
